The Lafferty Metering Tip Calculator will determine the dilution ratio for each color of metering tip based on the actual water pressure supplied to the specific unit being installed.
Unit Quick-Selection Mode
- For most products, simply type the model number or part of the product name into the “Select Unit” field to search for it. Click a unit in the list to select it.
- Once selected, the unit flow rate will automatically update to show specifications for the selected unit.
- For multifunction units, use the “Unit Bodies” toggle to switch between charts for each function. Foaming, sanitizing, high/low flow, etc.
- If necessary, make sure to enter the actual water pressure that is being provided to the unit. Refer to step 2 below.
Step-By-Step Instructions
- Provide the Unit Flow Rate for the unit being installed
- The Unit Flow Rate is a baseline value that is specific for each unit.
- Refer to the Flow Rate Chart on Page 2 of the Installation & Operation Instructions.
- Enter any of the GPM / PSI pairs into the Metering Tip Calculator as the Unit Flow Rate. It does not matter which pair is used, they will all return the same results.
- Provide the Actual Water Pressure (PSI) at the unit
- The Actual Pressure is the pressure of the water supply that is connected to the unit.
- If the unit is equipped with gauges, read the water pressure gauge with water flowing through the complete unit.
- Important: Use the “running” water pressure. Do not use the “static” pressure of a non-flowing water supply. The static pressure will read higher than the running water pressure and cause unexpected results. To determine the running water pressure, read the gauge with the unit connected to the water supply and water flowing through the injector, hose, and discharge assembly provided with the unit.
- If the unit is not equipped with gauges, use a Water Pressure Test Kit.
- Alternately, consult a plumber to determine the running water pressure.
- Click “Calculate”
- The results table will display the dilution ratio for each color of metering tip.
- The results are shown in several formats.
- Ratio (water:chemical)
- Percentage (by volume)
- Ounces per gallon
Screenshots
WEBSITE
Selecting a unit automatically populates the unit flow rate details. If the desired unit is not available for selection, select a similar model or enter the unit flow rate and pressure manually.
USING A PRESSURE WASHER?
When using a pressure washer with 969-series products, enter the rated flow of the pressure washer and set both the ‘unit’ and ‘actual’ PSI values to 1000.
For example: Your pressure washer says 5 GPM, 3500 PSI on the label. Enter the unit flow rate as 5 GPM @ 1000 PSI with actual water pressure of 1000 PSI.
